询问商人
木工加入
问题老门干扰
我买了新内门 适应我饭厅内现有框架
然而当我提供新门上转时,我可以看到链子挂起的侧端门框非直线
关闭检验中 侧计划过快到 约15至20毫米缺失
顶部和底部位置正确
有任何方法绕过这个或我需要新门干扰
感恩节
MyBuilder Carpenters和Ji
最佳回答
你好
It sounds like quite a bit ,if you have 15-20mm in the middle of your doorframe.normally I would plane the bow out, by planing the door.But in this case unless you have 15-20mm to spare on the width of the door?The best thing to do is change the doorframe or if it's possible you can try and to put a packer to the back of the middle of the frame.If this makes sense.Then put a screw through the packer and frame to hold in place, use a straight edge when doing this.That way your doorframe will be straight.If this is possible it means after fitting your door.装满螺丝洞
2017年1月28日回复
Aldershot应用·自2008年7月12日起成员·6作业,83%正数反馈
第一件事是检查开关框架大小新门应该有几毫米尺寸
上吊侧面有首可搭乘门适配弓多数内部门边缘带边框,这样你就可以平面向外鞠躬
新的内部门框需要,如果框架距离广场远并有弓
2017年1月27日回复
关联问题
- Hi 防火门中应包含哪些内容来遵守BS476 Part 22, 1987安装后,安装者能证明新门为防火证明吗?
Hi,房东安装新防火门 1987年BS476部分他用过
- Hi 防火门中应包含哪些内容来遵守BS476 Part 22, 1987安装后,安装者能证明新门为防火证明吗?
Hi,房东安装新防火门 1987年BS476部分他用过
- 取空柜换门用墙换门
90x90cm喷气柜 分两个房间 50/50
- 我不认为前门安装正确 我不认为前门对两院有效我们能请求替换门吗
门与框架或它所想相容,例如边框和门边没有重叠来防止